MaintenanceBeginner15 min

Chery Battery Maintenance & Replacement Guide

How to test, maintain, and replace your Chery's 12V battery. Signs of failure and replacement costs in Australia.

Tools & Materials Needed

  • Multimeter
  • Terminal cleaner
  • Wrench 10mm

Step-by-Step Instructions

  1. 1

    Battery location: Engine bay, usually on the right side (passenger side)

  2. 2

    Battery specs: 12V, 60-70Ah, 550-650 CCA (check owner's manual for exact spec)

  3. 3

    Testing battery: Use multimeter. Healthy battery = 12.6V (engine off). Below 12.2V = needs charging

  4. 4

    Load test: Start engine. Voltage should stay above 10V during cranking. Below 9.6V = weak battery

  5. 5

    Signs of weak battery: Slow cranking, dim lights, electrical glitches, battery warning light

  6. 6

    Cleaning terminals: Disconnect negative first, then positive. Clean with terminal brush and baking soda solution

  7. 7

    Battery life: Typically 3-5 years in Australia. Shorter in hot climates (NT, QLD)

  8. 8

    Replacement cost: $180-280 (battery) + $50-100 (labor if not DIY)

  9. 9

    DIY replacement: Disconnect negative terminal first, then positive. Remove hold-down clamp. Install new battery in reverse order

  10. 10

    Pro tip: If car sits unused for weeks, use a battery maintainer to prevent discharge

Applicable Models

Tiggo 4Tiggo 7Tiggo 8Arrizo 5Omoda 5

⚠️ Safety Notice:Always follow proper safety procedures when working on your vehicle. If you’re unsure, consult a professional mechanic. This guide is for informational purposes only.